Module 3: Make it factory-ready

Try-on and fit review

See your design on a model with Try-on, then review the physical samples the factory sews in Fit review, one round at a time.

You'll learn

A product with a size guide and the category Apparel. Fit review only appears for apparel. Lesson 6: Specs and the tech pack covers it.

Fit review compares what you measured on the sample with your size guide and flags what's out of tolerance.

0 of 5 done

Open Genpire in another tab and tick each step as you go.

Try it on a modelIn the editor, open Try-on. Under Virtual Try-On, pick one of the Genpire models, choose a model From Library or upload your own. Pick a shot, like Walking pose, natural light, and press Generate Try-On. The image appears in the chat and in the Try-on panel. It shows the look on a body; it doesn't measure the fit.
Open Fit reviewFit review is a Hand off section for apparel. If you don't see it, set the Category in Product details to Apparel.
Start a roundClick New round. Set the sample size and the status, and add front, back and side photos: drop or paste them, or choose from your revisions.
Enter what you measuredIn Measured vs spec, type the measurements you taped on the sample. Each one is compared with the spec in your size guide and flagged when it's outside the tolerance.
Comment and sealAdd fitting comments, or use Draft with AI. Move the status from Requested to Received, Comments sent and Sealed, and track approvals such as Wearer trial, Size set request and HLP / durability wash. With two rounds or more, you can compare them.

Name each round the way your factory does, like Blue Seal or Silver Seal, so everyone talks about the same sample.

Where do you see that a sample measurement is out of tolerance?

In Fit review, under Measured vs specIn Try-onIn the Specs tab

Mark it complete to save your progress and move on.